2G0947 - 31JAN08 8-5
Additional Service Procedures
Upgrading the HARD DRIVE with a New Version of System
Software - "Ghosting"
Save the backup file to your LAPTOP COMPUTER.
1. Make a backup of the configuration file for the IMAGER (see “Making a
Configuration Backup” on page 8-1).
2. De-energize the IMAGER.
3. Install the THUMB DRIVE containing the "ghost" software into one of the
USB ports on the DRE MOTHERBOARD.
4. Energize the IMAGER.
5. After "Ghosting’ has completed, de-energize the IMAGER.
Note: The IMAGER will "beep" several times when "ghosting" is complete.
6. Remove the THUMB DRIVE.
7. Energize the IMAGER.
USB Ports
DRE MOTHERBOARD
To Next Page
Loading...
