2G0947 - 31JAN08 3-37
Adjustments and Replacements
PROCESSOR ROLLERS
Prerequisites: Remove the “PROCESSOR COVER”.
To Remove:
The BEARINGS on the ends of each ROLLER are loose. Take care not to lose
the BEARINGS or the SPRINGS in the RETAINER.
1. Lift each ROLLER from the RETAINER.
To Install: 2. Install a BEARING on each end of the ROLLER, and make sure each
RETAINER includes a SPRING.
3. Insert the BEARINGS (with ROLLER) into the RETAINER.
4. Check that:
a. Each ROLLER rotates freely.
b. Each BEARING is free to slide against the SPRING in the
RETAINER.
c. The SPRINGS are not bent.
PROCESSOR COVER
RETAINER
ROLLER
BEARING
SPRING
To Next Page
Loading...
