2G0947 - 31JAN08 5-61
Diagnostics
Condition Code: 21-118 or 23-118
Description
This error occurs if the PICKUP fails to leave the home position at the
beginning of a pickup cycle or fails to reach the home position at the end of a
pickup cycle (as indicated by the PICKUP HOME SENSOR S1x). It can also
occur if the PICKUP did not go off-home or reached home unexpectedly. This
error can indicate a problem with the PICKUP HOME SENSOR (S1x) or
PICKUP DRIVE MOTOR (M3x). The error is cleared when a FILM TRAY is
re-inserted after being removed.
System Impact
One or more feed magazine(s) is unable to print. The spooler is still able to
accept and queue jobs and continue printing from any other available supply
tray.
User Action
1. Cover the FILM TRAY with the FILM SAVER.
2. Remove the FILM TRAY from the IMAGER.
3. Re-insert the FILM TRAY and remove the FILM SAVER.
4. If the error persists, call for service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
1. De-energize then energize the LASER IMAGER.
2. Do the following:
Web Portal Message Log Message DICOM Message Severity
xxxxx Supply: Internal
Hardware Failure
xxxxx Supply: Pickup Home
Sensor (S1x) failed to sense the
pickup assembly in the
appropriate home or off-home
position.
FILM TRANS ERR 1-Alert
Check: If an existing problem:
CONNECTORS and CABLES Seat all CONNECTORS.
PICKUP HOME SENSOR Install a new SENSOR (see Adjustments
and Replacements, “SENSOR, PICKUP
HOME - UPPER (S1U) and LOWER
(S1L)” on page 3-81).
To Next Page
Loading...
