2G0947 - 31JAN08 3-43
Adjustments and Replacements
4. Slide the 3 BELTS off the ROLLERS.
5. Disengage the TURNAROUND DRIVE BELT from the PULLEY.
6. Remove:
• 2 E-RINGS (1 on the outside of the PULLEY and 1 from inside the
FRAME)
• PULLEY
7. Push the DRIVE SHAFT to the right to disengage it from the BEARING
on the left side of the FRAME, then to the left to remove it.
3 BELTS
ROLLERS
DRIVE
SHAFT
2 E-RINGS
TURNAROUND
DRIVE BELT
PULLEY
BEARING
To Next Page
Loading...
