3-46 2G0947 - 31JAN08
Adjustments and Replacements
4. Slide the 3 BELTS off the ROLLERS.
5. Remove the E-RING from the inside left of the IDLER SHAFT.
NOTE: For the upper IDLER SHAFT you should remove the LEFT PANEL
INTERLOCK SWITCH (see “SWITCH, INTERLOCK - LEFT and
RIGHT PANELS” on page 3-19).
6. Using a straight slot SCREWDRIVER, unscrew the IDLER SHAFT from
the left side.
7. Push the IDLER SHAFT to the left to disengage it from the right side of
the FRAME, then to the left to remove it.
8. Remove:
• 6 E-RINGS
• 3 ROLLERS
To Install: 1. Reverse the steps in the removal procedure.
E-RING
3 BELTS
ROLLERS
IDLER
SHAFT
INTERLOCK
SWITCH
Left side of
IMAGER
6 E-RINGS
3 ROLLERS
IDLER SHAFT
To Next Page
Loading...
