Kyocera 408ci - Loading Originals in the Document Processor

5-3
Operation on the Machine > Loading Originals
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
The document processor supports the following types of originals.
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
1
Adjust the original width guides.
Detail Document Processor
(Automatic 2-Sided)
Document Processor
(Dual scan DP)
Document Processor
(Dual Scan with Skewed and
Multifeed Detection)
Type DP-5100 DP-5120 DP-5130
Weight
50 to 120 g/m
2
(duplex: 50 to 120 g/m
2
)
35 to 220 g/m
2
(duplex: 50 to 220 g/m
2
)
Sizes
Maximum 216 x 356 mm (Long-sized 216 x 1900 mm) to Minimum 105 x 148 mm
No. of
sheets
Plain paper (80 g/m
2
), Recycled
paper, Vellum paper: 75 sheets
(Mixed size originals: 75 sheets)
Thick paper (120 g/m
2
): 50 sheets
Art paper: 1 sheet
Plain paper (80 g/m
2
), Recycled
paper, Vellum paper: 100 sheets
(Mixed size originals: 100 sheets)
Thick paper (120 g/m
2
): 50 sheets
Art paper: 1 sheet
Plain paper (80 g/m
2
), Recycled
paper, Vellum paper: 270 sheets
(Mixed size originals: 30 sheets)
Thick paper (120 g/m
2
): 180 sheets
Art paper: 1 sheet
IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.