6-71
Using Various Functions > Functions
OHP Backing Sheet
When two or three OHP transparencies are stacked on top of each other, static electricity may make them difficult to
handle. When using OHP Backing Sheet, a paper sheet is automatically inserted between each transparency, making
them easier to handle. Also, the same original page can be printed to the backing sheet for multiple page printing.
Blank Sheet
Copied Sheet
Advanced
Setup
• For transparency film that can be used, refer to the following:
Transparencies
(page 11-16)
• Never load OHP transparencies into trays or cassettes other than the multipurpose tray.
• When OHP Backing Sheet is set, the multipurpose tray paper type is automatically set to "Transparency".
• If the optional 1,000-Sheet Finisher or 3,000-Sheet Finisher is installed, you may need to specify the output
destination for finished copies.
Paper Output
(page 6-30)
Outputs a blank backing sheet after printing to a transparency. (* denotes
transparency.)
After printing to a transparency, copies the same original image to the
backing sheet paper. (* denotes transparency.)
• Fan through the transparencies before loading.
• Up to 1 transparency can be loaded at one time.
• Be sure that paper of the same size and orientation as the transparencies is loaded in the cassette.
Item Value Description
Off
Blank Sheet,
Copied Sheet
Paper Source Auto, Cassette 1 (to 4) Select the media to be fed. When [Auto] is
selected, the machine automatically selects
media that matches the size of the original.
3
*
3
2
1
2
*
1
*
3
3
*
3
2
1
2
2
*
1
1
*
To Next Page
Loading...
