Kyocera 408ci - Sending Document Via E-Mail; Configuring Settings before Sending; Sending Scanned Document Via E-Mail

5-22
Operation on the Machine > Sending Document via E-mail
Sending Document via E-mail
When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (Client) (page 8-66)
Configuring Settings before Sending
Before sending an E-mail, configure the SMTP and E-mail settings using the Command Center RX.
E-mail Settings (page 2-68)
Sending Scanned Document via E-mail
1
[Home]( ) key > [Send]
2
Place the originals.
Loading Originals (page 5-2)
3
In the destination screen for sending, select [+] > [Email]
4
Enter destination E-mail address > [OK]
Up to 256 characters can be entered.
Character Entry Method
(page 11-9)
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to
100 E-mail addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [ Add to Address
Book
]. You can also replace the information for a previously registered destination.
Destinations can be changed later.
Confirmation Screen of Destinations
(page 5-47)
5
Select the functions.
Select the Global Navigation to display other functions.
Send (page 6-6)
NOTE
If [Prohibit] is set to “Broadcast”, multiple destinations cannot be entered.
Broadcast (page 8-37)