Kyocera 408ci - DSM Scan; Configuring Settings before Sending; Executing DSM Scan

5-35
Operation on the Machine > DSM Scan
DSM Scan
A scanned document can be automatically saved in any format or sent to any destination by reading a scan process
from Active Directory. This function only supports the computers installed Windows Server 2008 R2 or Windows Server
2012.
When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (Client) (page 8-66)
Configuring Settings before Sending
If you are performing DSM scan, check the items below.
• The machine is connected to an Active Directory on the network that the scan process can reference.
• "DSM Scan", "LDAP" and "HTTP" are set to [On] in Network.
• "Network" [SSL] is set to [On] in Security Settings.
•[Network Authentication] is set in.
Executing DSM Scan
1
[Home]( ) key > [Send]
2
Place the originals.
Loading Originals (page 5-2)
3
Display the screen.
In the destination screen for sending, select [+] > [DSM Scan]
Protocol Settings (page 8-57)
SSL (page 8-77)
Enabling User Login Administration (page 9-3)
NOTE
If the Active Directory that the scan process can reference is not on the network authentication server, DSM must be
set in Command Center RX.
Command Center RX User Guide
NOTE
Depending on the settings, the address book screen may appear. In this event, select
[Cancel] to display the destination screen for sending.