Kyocera 408ci - Executing WSD Scan

5-33
Operation on the Machine > WSD Scan
For Windows 7
1
Display [Network] in the Start menu.
Click [Start] button on the Windows and then select [Network].
2
Install the driver.
Right-click the machine's icon and then click [Install].
During the installation, double-click the icon shown on the task bar to display the "Driver
Software Installation" screen. When "Your devices are ready to use" is displayed on the
[Driver Software Installation] screen, the installation is completed.
Executing WSD scan
1
[Home]( ) key > [Send]
2
Place the originals.
Loading Originals (page 5-2)
3
Display the screen.
In the destination screen for sending, select [+] > [WSD Scan]
4
Scan the originals.
Procedure using this machine
1 [From Operation Panel] > [Next]
NOTE
When [Network] does not appear in the Start menu, perform the following procedure.
1 Right-click [Start] and click [Property] in the menu that appears.
2 Select the [[Start] menu] tab in the "Task bar and [Start] menu properties" screen, and
click [Customize].
3 When the "Customize [Start] menu" screen appears, select the "Network" check box
and click [OK].
NOTE
If the "User Account Control" window appears, click [Continue].
If the "Found New Hardware" window appears, click [Cancel].