2KJ/2KH
1-2-15
10. Insert two bands of the key counter wire to
the machine and shield cover.
11. Refit the shield cover.
Figure 1-2-20
12. Connect the 4-pin connector of the key
counter wire to the YC12 on the engine
PWB.
Put the 1-pin connector that is not con-
nected in the shield box.
13. Pull the other 4-pin connector out from the
aperture of the right middle cover.
14. Refit the rear cover.
Figure 1-2-21
Bands
Key counter wire
Shield cover
YC12
Aperture
4-pin
connector
4-pin
connector
Key counter wire
Engine PWB
To Next Page
Loading...
