Kyocera TASKalfa 255 - Page 248

9-18
Setup, Registration, and User Management > System Menu
IPv6 Settings Set up TCP/IP (IPv6) to connect to the network. The IPv6 setting is available when selecting
[On] for [TCP/IP Setting].
IPv6 Sets whether to use IPv6.
Value: Off, On
Manual Setting Manually specify the IP address, prefix length, and gateway address of TCP/IP (IPv6). The
manual setting is available when selecting [On] for TCP/IP (IPv6).
Value
IP Address (Manual): (numbers (128 bit in total) separated by colons)
Prefix Length: 0 to 128
Default Gateway: ###.###.###.###
RA (Stateless) Select whether or not to use RA (Stateless). The RA (Stateless) settings are available when
selecting [On] for TCP/IP (IPv6).
When selecting [On], [IP Address 1 (to 5)] appears under [IP Address (Stateless)/Prefix
Length].
Value: Off, On
DHCP Select whether or not to use the DHCP (IPv6) server. The DHCP (IPv6) Settings are available
when selecting [On] for TCP/IP (IPv6).*
Value: Off, On
Protocol Detail The table below lists the network related function settings. The network related functions are
available when [TCP/IP Setting] is [On].
NetBEUI Selects whether or not to receive documents using NetBEUI.*
Value: Off, On
LPD Select whether or not to receive documents using LPD as the network protocol.*
Value: Off, On
SMTP (E-mail TX) Select whether or not to send e-mail using SMTP.
Value: Off, On
POP3 (E-mail RX) Select whether or not to receive e-mail using POP3.
Value: Off, On
FTP Client
(Transmission)
Select whether or not to send documents using FTP. When selecting [On], set the FTP Port
Number. Use the FTP default port 21.
Value: Off, On, Port 1 - 65535
FTP Server (Reception) Select whether or not to receive documents using FTP.*
Value: Off, On
SMB Client
(Transmission)
Select whether or not to send documents using SMB. When selecting [On], set the SMB default
Port Number. Use the SMB default port 139. For Windows Vista, use 445.
Value: Off, On, Port 1 - 65535
LDAP Select whether or not to use LDAP.
Value: Off, On
SNMP Select whether or not to communicate using SNMP.*
Value: Off, On
SNMPv3 Select whether or not to communicate using SNMPv3.*
Value: Off, On
HTTP Select whether or not to communicate using HTTP.*
Value: Off, On
Item Description