Lenovo ThinkServer RD330 - Page 358

Page 358
MegaRAID SAS Software User GuideChapter 11: Using MegaRAID® Advanced Software
| SafeStore Encryption Services
Figure 241: Change Security Settings
3. Select the Change current security settings option in Figure241, if you want to
change the drive security settings on the controller using the LKM mode.
When you select this option, the details of the Change current security settings
given in Section11.5.10, Changing the Drive Security Settings is displayed.
4. Select Switch to External key management (EKM) mode, if you want to switch
over from LKM mode to EKM mode.
5. Click OK.
After you click OK, the authentication drive security key is generated internally by
the system.
11.5.3.1 Authentication Drive
Security Key
After you obtain the authentication drive security key from the EKM mode, enter the
authentication drive security key in the Authentication Drive Security Key dialog box
as shown in the following figure.
.
Figure 242: Authentication Drive Security Key
If you enter a valid authentication key, a confirmation message indicating that EKM is
enabled is displayed as shown in the following figure.