Lenovo ThinkServer sd350 - Using the Setup Utility

•SupportGPTpartitionmode(>2.2TBvolumesandarrays)
•SupportHypervisorsinstall
•ServerIntroduction(ChineseandEnglishonly)
Windowsonlyfeatures
•AllowentriesforGUIRun-Oncelinevariables
•Installwindowscomponents
•Networkconfiguration
•Auto-generatecomputername
UsingtheSetuputility
UsetheseinstructionstostarttheSetuputility.
UsetheUnifiedExtensibleFirmwareInterface(UEFI)SetupUtilityprogramtoperformthefollowingtasks:
•Viewconfigurationinformation
•ViewandchangeassignmentsfordevicesandI/Oports
•Setthedateandtime
•Setandchangepasswords
•Setthestartupcharacteristicsoftheserverandtheorderofstartupdevices
•Setandchangesettingsforadvancedhardwarefeatures
•View,set,andchangesettingsforpower-managementfeatures
•Viewandclearerrorlogs
•Changeinterruptrequest(IRQ)settings
•Resolveconfigurationconflicts
StartingtheSetuputility
UsethisinformationtostartuptheSetuputility.
TostarttheSetuputility,completethefollowingsteps:
Step1.Turnontheserver.
Note:Approximately5to10secondsaftertheserverisconnectedtopower,thepower-control
buttonbecomesactive.
Step2.Whentheprompt<F1>Setupisdisplayed,pressF1.Ifyouhavesetanadministratorpassword,
youmusttypetheadministratorpasswordtoaccessthefullSetuputilitymenu.Ifyoudonottype
theadministratorpassword,alimitedSetuputilitymenuisavailable.
Step3.Selectsettingstovieworchange.
Setuputilitymenuchoices
UsetheSetuputilitymainmenutoviewandconfigureserverconfigurationdataandsettings.
ThefollowingchoicesareontheSetuputilitymainmenufortheUEFI.Dependingontheversionofthe
firmware,somemenuchoicesmightdifferslightlyfromthesedescriptions.
•Main
34LenovoThinkServersd350ServerType5493,LenovoThinkServern400EnclosureType5495InstallationandServiceGuide