Install the front OCP module
Follow instructions in this section to install the front OCP module.
About this task
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 62.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Remove the OCP module filler if there is.
Step 3. Install the front OCP module.
Figure 50. Installing the front OCP module
a.
Push the OCP module into the slot until it is fully seated.
b.
Tighten the thumbscrew to secure the OCP module. Use a screwdriver if needed.
Chapter 5. Hardware replacement procedures 93
To Next Page
Loading...
