Lenovo ThinkSystem SR665 V3 - Install an M.2 Drive

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack. See
“Remove the server from rack” on page 63.
Step 2. Remove the top cover. See
“Remove the top cover” on page 277.
Step 3. Remove the M.2 drive.
Figure 102. Removing the M.2 drive
a. Press both sides of the retainer 2 .
b.
Slide the retainer away from the M.2 drive.
c.
Rotate the rear end of M.2 drive to an angle of approximately 30 degrees.
d.
Pull the M.2 drive away from the connector 1 .
After you finish
1. Install a new M.2 drive. See “Install an M.2 drive” on page 144.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube (on air baffle)
Watch the procedure on YouTube (on middle drive cage)
Install an M.2 drive
Follow instructions in this section to install an M.2 drive.
Attention:
144
ThinkSystem SR665 V3 User Guide