Lenovo ThinkSystem SR665 V3 - One 8 X Anybay Backplane

Figure 298. Cable routing when two processors installed
Figure 299. Cable routing when one processor installed
From To From To
1 Backplane 1: SAS 1 CFF adapter
• C0
• C1
1 Backplane 1: SAS 1 CFF adapter
• C0
• C1
2 CFF adapter: MB (CFF
INPUT)
2 Onboard: PCIe 5 2 CFF adapter: MB (CFF
INPUT)
2 Onboard: PCIe 2
3 CFF adapter: PWR 3 Onboard: CFF RAID/
HBA PWR
3 CFF adapter: PWR 3 Onboard: CFF RAID/
HBA PWR
One 8 x AnyBay backplane
This section provides cable routing information for the server model with one 8 x 2.5-inch AnyBay front
backplane.
To connect power cables for the front backplane(s), refer to
“Backplanes: server models with 2.5-inch front
drive bays” on page 312
.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
• “8i/16i RAID/HBA adapter” on page 317
• “CFF 8i/16i RAID/HBA adapter” on page 318
8 x AnyBay
This topic provides cable routing information for the 8 x 2.5-inch AnyBay configuration.
• “8i/16i RAID/HBA adapter” on page 317
316
ThinkSystem SR665 V3 User Guide