Lenovo ThinkSystem SR665 V3 - Remove the Firmware and Rot Security; Module; Install the Firmware and Rot Security; Remove the System I;O Board or Processor

Figure 226. System-board-assembly layout
1 System I/O board
2 Firmware and RoT security module 3 Processor board
•
“Remove the firmware and RoT security module” on page 249
• “Install the firmware and RoT security module” on page 251
• “Remove the system I/O board or processor board” on page 255
• “Install the system I/O board or processor board” on page 259
Remove the firmware and RoT security module
Follow instructions in this section to remove the ThinkSystem V3 Firmware and Root of Trust Security
Module (firmware and RoT security module).
About this task
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do no
attempt to remove or install it without proper training and qualification.
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 249