• Make sure that all internal cables are correctly routed. See Chapter 6 “Internal cable routing” on page 281.
• Handle the top cover carefully. Dropping the top cover with the cover latch open might damage the cover
latch.
Procedure
Figure 247. Installing the top cover
Step 1. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until both
sides of the top cover engage with the guides on both sides of the chassis. Then, slide the top
cover to the front of the chassis.
Note: Before you slide the top cover forward, ensure that all the tabs on the top cover engage with
the chassis correctly.
Step 2. Rotate the cover latch until the top cover snaps into position. Ensure that the cover latch is
completely closed.
Step 3. Use a screwdriver to turn the cover lock to the locked position.
Demo video
Watch the procedure on YouTube
Complete the parts replacement
Go through the checklist to complete parts replacement
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
Chapter 5. Hardware replacement procedures 279
To Next Page
Loading...
