Figure 170. Removing the 7mm SSD riser cage
Step 3. (Only for the 2FH+7mm SSD riser cage) Remove the 7mm drive cage from the riser assembly.
Figure 171. Removing the 7mm drive cage from the riser assembly
a. Remove the two screws.
b.
Slightly and horizontally slide the cage out of the riser cage.
After you finish
Remove the two 7mm backplanes. See
“Remove the 7mm drive backplanes” on page 207.
Demo video
Watch the procedure on YouTube
Remove the 7mm drive backplanes
Follow instructions in this section to remove the 7mm drive backplanes.
About this task
Chapter 5. Hardware replacement procedures 207
To Next Page
Loading...
