Install the 7mm drive cage. See “Install the 7mm drive cage” on page 211.
Demo video
Watch the procedure on YouTube
Install the 7mm drive cage
Follow instructions in this section to install the 7mm drive cage.
About this task
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 62.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. (Only for the 2FH+7mm SSD riser cage) Hook the securing clip over the riser adapter on the riser
cage.
Figure 176. Installing the 7mm drive cage securing clip
Step 2. (Only for the 2FH+7mm SSD riser cage) Install the 7mm drive cage to the riser assembly.
Chapter 5. Hardware replacement procedures 211
To Next Page
Loading...
