Lenovo ThinkSystem SR665 V3 User Manual

Step 3. Connect the cables to the drive backplane. See Chapter 6 “Internal cable routing” on page 281.
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
“Install a hot-swap drive” on page 134.
2. Reinstall the fan cage. See
“Install the system fan cage” on page 270.
3. Reinstall the air baffle if you have removed it. See
“Install the air baffle” on page 72.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 279.
Demo video
Watch the procedure on YouTube
Front I/O module replacement
Follow instructions in this section to remove and install the front I/O module.
The front I/O module varies by model. The front I/O module for most models is on the right rack latch. The
front I/O module on media bay is supported only in the following server models:
• Server models with eight 2.5-inch front drive bays
• Server models with sixteen 2.5-inch front drive bays
Front I/O module (on rack latch)
Front I/O module (on media bay)
Depending on the server model, the server might come with one of the following front I/O module on media
bay:
120
ThinkSystem SR665 V3 User Guide

Lenovo ThinkSystem SR665 V3 Specifications

General

Cores per Processor	Up to 96 cores
Form Factor	2U Rack
Management	Lenovo XClarity Controller
Processor	AMD EPYC 9004 Series
Memory	Up to 6TB DDR5
Memory Slots	32x DIMM slots
Storage	Up to 40x 2.5" drives
Drive Bays	Up to 40x 2.5" or 20x 3.5" drives (front and rear)
RAID Support	RAID 0, 1, 10, 5, 50, 6, 60
Expansion Slots	Up to 7 PCIe 5.0 slots
Network	1GbE, 10GbE, 25GbE
Power Supply	Up to 2x hot-swap redundant power supplies
Operating System Support	Windows Server, VMware