Figure 238. Installing the system fan cage
Step 1. Align the system fan cage with the mounting guides on both sides of chassis, and lower it into the
chassis.
Step 2. Rotate the fan cage levers down until the fan cage clicks into place.
Note: If there are system fans installed in the system fan cage, ensure that the system fans are
correctly connected to the system fan connectors on the system board assembly.
After you finish
1. If you have removed the system fans, reinstall them. See
“Install a system fan” on page 266.
2. Complete the parts replacement. See “Complete the parts replacement” on page 279.
Demo video
Watch the procedure on YouTube
Serial port module replacement
Follow instructions in this section to remove and install a serial port module.
•
“Remove a serial port module” on page 271
• “Install a serial port module” on page 274
Remove a serial port module
Follow instructions in this section to remove a serial port module.
About this task
Attention:
Chapter 5. Hardware replacement procedures 271
To Next Page
Loading...
