Step 3. Connect the M.2 cables to M.2 backplane.
Figure 113. Connecting M.2 cables to M.2 backplane
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 279.
Demo video
Watch the procedure on YouTube (on air baffle)
Watch the procedure on YouTube (on middle drive cage)
Memory module replacement
Follow instructions in this section to remove and install a memory module.
•
“Remove a memory module” on page 152
• “Install a memory module” on page 154
Remove a memory module
Follow instructions in this section to remove a memory module.
About this task
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
• Make sure to remove or install memory module 20 seconds after disconnecting power cords from the
system. It allows the system to be completely discharged of electricity and safe for handling memory
module.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines for “Handling static-sensitive devices” on page 50.
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
152 ThinkSystem SR665 V3 User Guide
To Next Page
Loading...
