Front
bays
Max.
Tem-
p.
Processor
Heat
sink
Air
baffle
Fan
type
Max. GPU Qty. Support
DIMMs
>= 96
GB
SW
DW
(A2000)
DW
(A40)
DW
(H100)
Other
DW
8 x
2.5"
30°C
Group B
2U S S P 10 3 NA NA NA Y
Group A
2U P S P 10 3
NA NA NA Y*
Group B, A
2U P GPU P NA NA
2 (slot 2/
5)
3 3 Y
16 x
2.5"
30°C
Group B
2U S S P 10 3 NA NA NA Y
Group A
2U P S P 10 3
NA
NA
NA Y*
Group B, A
2U P GPU P NA NA
2 (slot 2/
5)
2 (slot 2/
5)
3 Y
8 x
3.5"
30°C
Group B
2U S S P 10 3 NA NA NA Y
Group A
2U P S P 10 3
NA NA NA Y*
Group B, A
2U P GPU P NA NA 3 3 3 Y
8 x
2.5"
16 x
2.5"
8 x
3.5"
25°C
Group B
2U S S P 6 3 NA NA NA Y
25°C
Group A, E
2U P S P 6 3 NA NA NA Y
25°C
Group B,
A, E
2U P GPU P NA NA NA
2 (slot 2/
5)
2 (slot 2/
5)
Y
24 x
2.5"
25°C
Group B
2U S S P 6 3 NA NA NA Y
Group A
2U P S P 6 3 NA NA NA Y*
Group B, A
2U P GPU P NA NA NA
2 (slot 2/
5)
2 (slot 2/
5)
Y*
Notes:
• Group E processors in the table above include 9654(P), 9554(P), 9174F, 9754, and 9734.
• For GPU configurations, the Max. Temp. of 25°C is supported under the following conditions:
– A part with AOC and at a rate greater than 25 GB is not installed in slot 3.
– The following parts are not installed:
– Broadcom 57416 10GBASE-T 2-port OCP
– Broadcom 57454 10GBASE-T 4-port OCP
Power on and power off the server
Follow instructions in this section to power on and power off the server.
Power on the server
After the server performs a short self-test (power status LED flashes quickly) when connected to input power,
it enters a standby state (power status LED flashes once per second).
Power button location and power LED are specified in:
Chapter 5. Hardware replacement procedures 61
To Next Page
Loading...
