Figure 146. Installing the cable retainer
Step 5. Connect the cables to the system board assembly. See Chapter 6 “Internal cable routing” on page
281
.
After you finish
1. Install the air baffle. See
“Install the air baffle” on page 72.
2. Install the security bezel if you have removed it. See
“Install the security bezel” on page 246.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 279.
RAID flash power module replacement
The RAID flash power module protects the cache memory on the installed RAID adapter. Follow instructions
in this section to remove and install a RAID flash power module (also called supercap).
The location of RAID flash power modules varies by the server hardware configurations.
Chapter 5. Hardware replacement procedures 189
To Next Page
Loading...
