2 Power connector on
backplane 2
2 Onboard: backplane 2
power connector
2 Power connector 2 on
backplane
2 Onboard: backplane 2
power connector
2 Power connector on
backplane 3
3 Onboard: backplane 3
power connector
Signal cable connections
Refer to the specific topic for signal cable connections depending on the backplanes you have installed.
• One front backplane:
–
“One 8 x SAS/SATA backplane” on page 313
– “One 8 x AnyBay backplane” on page 316
– “One 8 x NVMe backplane” on page 327
• Two front backplanes:
–
“Two 8 x SAS/SATA backplanes” on page 330
– “Two 8 x AnyBay backplanes” on page 339
– “Two 8 x NVMe backplanes” on page 341
– “One 8 x SAS/SATA and one 8 x AnyBay backplanes” on page 343
– “One 8 x AnyBay and one 8 x NVMe backplanes” on page 359
• Three front backplanes:
–
“Three 8 x SAS/SATA backplanes” on page 362
– “Three 8 x AnyBay backplanes” on page 401
– “Three 8 x NVMe backplanes” on page 403
– “One 8 x AnyBay and two 8 x NVMe backplanes” on page 408
– “One 8 x SAS/SATA and two 8 x NVMe backplanes” on page 413
– “Two 8 x SAS/SATA and one 8 x AnyBay (Gen 4) backplanes” on page 415
– “Two 8 x SAS/SATA and one 8 x AnyBay (Gen 5) backplanes” on page 418
– “Two 8 x SAS/SATA and one 8 x NVMe (Gen 4) backplanes” on page 421
– “Two 8 x SAS/SATA and one 8 x NVMe (Gen 5) backplanes” on page 426
– “24 x 2.5-inch SAS/SATA expander backplane” on page 431
One 8 x SAS/SATA backplane
This section provides cable routing information for the server model with one 8 x 2.5-inch SAS/SATA front
backplane.
To connect power cables for the front backplane(s), refer to
“Backplanes: server models with 2.5-inch front
drive bays” on page 312
.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
• “Onboard connectors” on page 314
• “8i/16i RAID/HBA adapter” on page 314
• “CFF 8i/16i RAID/HBA adapter” on page 315
Chapter 6. Internal cable routing 313
To Next Page
Loading...
