Front I/O connectors
This section provides cable routing information for the front I/O connectors, including the VGA connector,
external diagnostics connector, front operator panel connectors, and front USB connector.
•
“Front I/O connectors on rack latches” on page 289
• “Front I/O connectors on the media bay” on page 289
Front I/O connectors on rack latches
Note: When routing a cable on the rack latch, ensure that it is fixed on the upper frame of the cable retainer.
For details, refer to
“Install the rack latches” on page 187.
Figure 264. Front VGA connector and external diagnostics
connector (left rack latch)
Figure 265. Front operator panel and USB connectors
(right rack latch)
From To From To
1 VGA cable 1 VGA connector on the
system board assembly
1 Front operator panel and
USB cable
1 FIO and USB connectors
on the system board
assembly
2 External diagnostics
cable
2 External diagnostics
connector on the system
board assembly
Front I/O connectors on the media bay
The illustration shows the cable routing for the front operator panel and front USB connectors on the media
bay.
Chapter 6. Internal cable routing 289
To Next Page
Loading...
