1 Front operator panel (without LCD display)
1 Integrated diagnostics panel (with LCD display)
To replace the front I/O module on the rack latch, see
“Rack latches replacement” on page 184.
To replace the front I/O module on the media bay:
• “Remove the front I/O module” on page 121
• “Install the front I/O module” on page 123
Remove the front I/O module
Follow instructions in this section to remove the front I/O module.
About this task
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 62.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Make preparation for the task.
a. If the security bezel is installed, remove it. See
“Remove the security bezel” on page 245.
b. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
“Remove the server from rack” on page 63.
c. Remove the top cover. See
“Remove the top cover” on page 277.
d. Remove the air baffle. See
“Remove the air baffle” on page 70.
Step 2. Disconnect the cables of the front I/O module from the system board assembly.
Notes:
Chapter 5. Hardware replacement procedures 121
To Next Page
Loading...
