Figure 87. Removing the riser 1 assembly with GPU adapter
a. Open the blue latch on the GPU air baffle.
b.
Loosen the screw that secures the riser assembly.
c.
Grasp the riser assembly by its edges and carefully lift it straight up and off the chassis.
GPU adapter on riser 3 assembly
a. Open the blue latch on the GPU air baffle.
b. Slightly lift the riser 3 assembly up, and remove the GPU air baffle. See
“Remove the air baffle”
on page 70
.
c. Disconnect riser 3 and GPU adapter cables from the system board assembly.
Notes:
• If you need to disconnect cables from the system board assembly, disengage all latches or
release tabs on cable connectors first. Failing to release the tab before removing the cables
will damage the cable sockets on the system board assembly. Any damage to the cable
sockets might require replacing the processor board or system I/O board.
Chapter 5. Hardware replacement procedures 127
To Next Page
Loading...
