Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
“Remove the server from rack” on page 63.
b. Remove the top cover. See
“Remove the top cover” on page 277.
c. Remove the system fans from the fan cage. See
“Remove a system fan” on page 264.
d. Remove the fan cage from the system board assembly. See
“Remove the system fan cage” on
page 269
.
Step 2. Rotate the fan cage by 90 degrees in the direction shown in the picture.
Figure 97. Rotating the fan cage
Step 3. Remove the intrusion switch assembly from the fan cage.
Figure 98. Removing the intrusion switch
140 ThinkSystem SR665 V3 User Guide
To Next Page
Loading...
