a. Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a RAID flash power module on the air baffle
Follow instructions in this section to install a RAID flash power module (also called supercap) on the air baffle.
About this task
Attention:
• Read
“Installation Guidelines” on page 47 and “Safety inspection checklist” on page 48 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 62.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the RAID flash power module on the air baffle.
Figure 156. Installing the RAID flash power module on the air baffle
a. Open the retention clip on the holder.
b.
Put the RAID flash power module into the holder.
Chapter 5. Hardware replacement procedures 195
To Next Page
Loading...
