Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the drive backplane into the rear drive cage.
Figure 186. Installing the 8 x 2.5-inch rear drive backplane
a. Align the pins of the backplane with the holes at both sides of the drive cage.
b. Lower the backplane into the drive cage so that the pins of the backplane pass through the
holes on the drive cage, and press the backplane into position.
Step 3. Install the rear drive cage.
Figure 187. Installing the 8 x 2.5-inch rear drive cage
Chapter 5. Hardware replacement procedures 219
To Next Page
Loading...
