Riser 5 + OCP interposer cards + 16i RAID/HBA adapter
The following shows the cable connections for the front (8 x 2.5-inch SAS/SATA + 8 x 2.5-inch AnyBay)
configuration with riser 5, front and rear OCP interposer cards, and one rear 16i RAID/HBA adapter.
To connect riser 5 cables, see
“Riser 5 cage” on page 309.
To connect cables to the front and rear OCP interposer cards, see
“OCP interposer cards” on page 297.
Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Backplane cable routing
Figure 351. SAS/SATA cable routing
Figure 352. NVMe cable routing
From To From To
1 Backplane 1: SAS
1 16i adapter
• Gen 4: C0
• Gen 3: C0C1
1 Backplane 2: NVMe 0-1
1 Onboard: PCIe 4
2 Backplane 2: SAS
2 16i adapter
• Gen 4: C1
• Gen 3: C2C3
2 Backplane 2: NVMe 2-3
2 Onboard: PCIe 3
3 Backplane 2: NVMe 4-5
3 Onboard: PCIe 2
4 Backplane 2: NVMe 6-7
4 Onboard: PCIe 1
Chapter 6. Internal cable routing 351
To Next Page
Loading...
