Riser 3/4/5 + 16i RAID/HBA adapter + Retimer card
The following shows the cable connections for the front (8 x 2.5-inch SAS/SATA + 8 x 2.5-inch AnyBay)
configuration with riser 3, 4, and 5, one 16i RAID/HBA adapter, and one retimer card.
To connect riser 3 and riser 4 cables, see
“Riser 3/4 cage” on page 306.
To connect riser 5 cables, see
“Riser 5 cage” on page 309.
Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Backplane cable routing
Figure 355. SAS/SATA cable routing
Figure 356. NVMe cable routing
From To From To
1 Backplane 1: SAS
1 16i adapter
• Gen 4: C0
• Gen 3: C0C1
1 Backplane 2: NVMe 0-1
1 Onboard: PCIe 5
2 Backplane 2: SAS
2 16i adapter
• Gen 4: C1
• Gen 3: C2C3
2 Backplane 2: NVMe 2-3
2 Onboard: PCIe 7
3 Backplane 2: NVMe 4-5
3 Retimer card: C0
4 Backplane 2: NVMe 6-7
4 Retimer card: C1
12 x SAS/SATA + 4 x NVMe
The following shows the cable connections for the front (12 x 2.5-inch SAS/SATA + 4 x 2.5-inch NVMe)
configuration.
Chapter 6. Internal cable routing 353
To Next Page
Loading...
