NVMe cable routing
Figure 362. Cable routing when two processors installed
Figure 363. Cable routing when one processor installed
From To From To
1 Backplane 2: NVMe 0-1
1 Onboard: PCIe 6
1 Backplane 2: NVMe 0-1
1 Onboard: PCIe 2
2 Backplane 2: NVMe 2-3
2 Onboard: PCIe 8
2 Backplane 2: NVMe 2-3
2 Onboard: PCIe 1
3 Backplane 2: NVMe 4-5
3 Onboard: PCIe 9
3 Backplane 2: NVMe 4-5
3 Onboard: PCIe 9
4 Backplane 2: NVMe 6-7
4 Onboard: PCIe 10, 11
4 Backplane 2: NVMe 6-7
4 Onboard: PCIe 10, 11
Riser 5 + OCP interposer cards + 8i RAID/HBA adapter
The following shows the cable connections for the front (8 x 2.5-inch SAS/SATA + 8 x 2.5-inch NVMe)
configuration with riser 5, front and rear OCP interposer cards, and one rear 8i RAID/HBA adapter.
To connect riser 5 cables, see
“Riser 5 cage” on page 309.
To connect cables to the front and rear OCP interposer cards, see
“OCP interposer cards” on page 297.
Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Chapter 6
. Internal cable routing 357
To Next Page
Loading...
