Rack front
Figure 21. Lifting up the server
1
Lift point
Rack Front
Figure 22. Removing the server from the rack.
1
Release tab
a.
Press the release tabs to disengage the rails from the server.
b.
Carefully lift up the front end of the server slightly to detach the nailheads from the slots on
the rails.
c.
Lift up the server to remove it from the rails completely. Place the server on a flat and sturdy
surface.
After you finish
Carefully lay the server on a flat, static-protective surface.
Chapter 5. Hardware replacement procedures 65
To Next Page
Loading...
