Figure 40. Removing the riser card from the riser 5 cage
a. Remove the screws that secure the riser card.
b.
Rotate the riser card from the top to disengage it from the screw holes on the riser cage.
c.
Lift the riser card out of the riser cage.
Step 6. Remove the OCP module from the front OCP cage.
Figure 41. Removing the OCP module
a. Loosen the thumbscrew that secures the OCP module.
b.
Pull out the OCP module.
Step 7. Remove the front OCP interposer card.
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
