LevelOne GSW-4876 - Page 38

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 38 –
Access
Management
Sets IP addresses of clients allowed management access via
HTTP/HTTPS, and SNMP, and Telnet/SSH
67
SNMP Simple Network Management Protocol 68
System Configures read-only and read/write community strings for
SNMP v1/v2c, engine ID for SNMP v3, and trap parameters
69
Communities Configures community strings 73
Users Configures SNMP v3 users on this switch 74
Groups Configures SNMP v3 groups 76
Views Configures SNMP v3 views 77
Access Assigns security model, security level, and read/write views
to SNMP groups
78
RMON Remote Monitoring 79
Statistics Enables collection of statistics on a physical interface 79
History Periodically samples statistics on a physical interface 80
Alarm Sets threshold bounds for a monitored variable 81
Event Creates a response for an alarm 83
Network
Limit Control Configures port security limit controls, including secure
address aging; and per port security, including maximum
allowed MAC addresses, and response for security breach
84
NAS Configures global and port settings for IEEE 802.1X 87
ACL Access Control Lists 98
Ports Assigns ACL, rate limiter, and other parameters to ports 98
Rate Limiters Configures rate limit policies 100
Access Control
List
Configures ACLs based on frame type, destination MAC type,
VLAN ID, VLAN priority tag; and the action to take for
matching packets
101
DHCP Dynamic Host Configuration Protocol
Snooping Enables DHCP snooping globally; and sets the trust mode for
each port
108
Relay Configures DHCP relay information status and policy 111
IP Source Guard Filters IP traffic based on static entries in the IP Source
Guard table, or dynamic entries in the DHCP Snooping table
112
Configuration Enables IP source guard and sets the maximum number of
clients that can learned dynamically
112
Static Table Adds a static addresses to the source-guard binding table 114
ARP Inspection Address Resolution Protocol Inspection 116
Configuration Enables inspection globally, and per port 117
Static Table Adds static entries based on port, VLAN ID, and source MAC
address and IP address in ARP request packets
118
AAA Configures RADIUS authentication server, RADIUS
accounting server, and TACACS+ authentication server
settings
119
Table 4: Main Menu (Continued)
Menu Description Page