Linksys Voice System Administration Guide 170
Voice tab
Voice tab > SIP page
Internal Music Source Parameters section
SIP DIDN Field Determines which field is used to indicate the DID number for an
incoming INVITE to a line interface. The choices are:
TO UserID—The user-id field of the TO header
TO Param—A parameter in the TO header with the name specified in
<SIP DIDN Param Name>, such as didn=1234
Default: TOUserID
SIP DIDN Param Name Parameter name to indicate the DID number in an incoming INVITE
message.
Default: didn
Accept All MWI as Line Choose the line. Choices are 1, 2, 3, 4, or Current.
Default: Current
Phone DLG Refresh Intvl Default: 0
Internal Music URL URL from which to download a music file to be used by the parking lot.
The format is:
[tftp://]server-ip-addr[:port]/path
TFTP is the only protocol supported for music download. Default port is
69. Changing the value of this parameter from the web interface
triggers a graceful reboot of the SPA9000. If a valid entry is specified, the
SPA9000 attempts to download the file on bootup and store the
samples in flash memory. The SPA9000 remembers the link where the
stored file is downloaded and does not try to download again on the
next reboot.
The music samples are encoded in G711u format at 8000 samples/
second. The file should not contain any extra header information.
Maximum length of the file is 65.536 seconds (524288 bytes).
Default: blank
To Next Page
Loading...
