Linksys SPA9000

Linksys Voice System Administration Guide 171
Voice tab
Voice tab > SIP page
Auto Attendant Parameters section
Internal Music Script Script that tells the SPA9000 how to play the downloaded music file, in
the format [section[,section[,…]]], where:
section = [[n](start/end[/pause])][pause2]
n = number of times to repeat the section before moving to the next
section. Default: 1
start/end = starting and 1+ending sample for this section; note that
samples are numbered from 0 to total-length – 1. You may enter –1 or a
very large number if the end of the file is intended as the ending sample.
Default start is 0, and default end is end of the file.
pause = number of samples to pause after the ending sample is played.
Default: 0
pause2 = additional number of samples to pause after the entire n
repetitions of the section are played. Default: 0
A maximum of 16 sections can be specified. Samples should be
encoded in G711u format at 8000 samples/second. When all sections
are played, the SPA9000 replays from the first section again.
Examples:
40000 (plays the entire file, pauses for 5s, then repeats)
2(0/32000),3(32000/100000/4000)2000,(100000/-1)80000
Internal Music Refresh Intvl The interval in seconds between refreshing an internal music session.
Default: 0 (disables session refreshes)
Internal Music LBR Codec Selects one low bit-rate codec as an alternative to G711u and G711a for
playing internal music. Choices are {none, G729a, G726-16, G726-24,
G726-32, G726-40}.
Default: none
Internal Music Preferred
Codec
Selects which codec is the preferred choice to play internal music.
Choices are {G711u, G711a, Low Bit Rate}. Low Bit Rate refers to the
selected <Internal Music LBR Codec>. If <Internal Music LBR Codec> is
none, G711u is the preferred codec also.
Default: G711u
Internal Music Use Pref
Codec Only
Forces the internal music player to use the preferred codec only.
Default: no
AA Dial Plan 1 Dial Plan 1 to be used in an AA script. Example: <dialplan src=dp1/>.
Default: (10x|xxx.)
AA Dial Plan 2 Dial Plan 2 to be used in an AA script. Example: <dialplan src=dp2/>.
Default: (<:10>x|xxx.)