Linksys SPA9000

Linksys Voice System Administration Guide 177
Voice tab
Prompt Tone Prompts the user to enter a call forwarding phone number.
Default: 520@-19,620@-19;10(*/0/1+2)
Busy Tone Played when a 486 RSC is received for an outbound call.
Default: 480@-19,620@-19;10(.5/.5/1+2)
Reorder Tone Played when an outbound call has failed or after the far end hangs up
during an established call. Reorder Tone is played automatically when
<Dial Tone> or any of its alternatives times out.
Default: 480@-19,620@-19;10(.25/.25/1+2)
Off Hook Warning Tone Played when the caller has not properly placed the handset on the
cradle. Off Hook Warning Tone is played when Reorder Tone times out.
Default: 480@10,620@0;10(.125/.125/1+2)
Ring Back Tone Played during an outbound call when the far end is ringing.
Default: 440@-19,480@-19;*(2/4/1+2)
Confirm Tone Brief tone to notify the user that the last input value has been accepted.
Default: 600@-16; 1(.25/.25/1)
SIT1 Tone Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable on
the SIP screen.
Default: 985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/
3,0/4/0)
SIT2 Tone Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The response status code (RSC) to trigger this
tone is configurable on the SIP screen.
Default: 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/
3,0/4/0)
SIT3 Tone Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable on
the SIP screen.
Default: 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/
3,0/4/0)
SIT4 Tone This an alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
Default: 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/
3,0/4/0)
MWI Dial Tone Played instead of the Dial Tone when there are unheard messages in the
caller’s mailbox.
Default: 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2)
Cfwd Dial Tone Played when all calls are forwarded.
Default: 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2)
Holding Tone Informs the local caller that the far end has placed the call on hold.
Default: 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1)
Conference Tone Played to all parties when a three-way conference call is in progress.
Default: 350@-19;20(.1/.1/1,.1/9.7/1)