Linksys Voice System Administration Guide 183
Voice tab
Block CID Per Call Act Code Blocks caller ID on the next outbound call.
Default: *81
Block CID Per Call Deact
Code
Removes caller ID blocking on the next inbound call.
Default: *82
Block ANC Act Code Blocks all anonymous calls.
Default: *77
Block ANC Deact Code Removes blocking of all anonymous calls.
Default: *87
DND Act Code Enables the do not disturb feature.
Default: *78
DND Deact Code Disables the do not disturb feature.
Default: *79
CID Act Code Enables caller ID generation.
Default: *65
CID Deact Code Disables caller ID generation.
Default: *85
CWCID Act Code Enables call waiting, caller ID generation.
Default: *25
CWCID Deact Code Disables call waiting, caller ID generation.
Default: *45
Dist Ring Act Code Enables the distinctive ringing feature.
Default: *26
Dist Ring Deact Code Disables the distinctive ringing feature.
Default: *46
Speed Dial Act Code Assigns a speed dial number.
Default: *74
Secure All Call Act Code Makes all outbound calls secure.
Default: *16
Secure No Call Act Code Makes all outbound calls not secure.
Default: *17
Secure One Call Act Code Makes the next outbound call secure. (It is redundant if all outbound
calls are secure by default.)
Default: *18
Secure One Call Deact Code Makes the next outbound call not secure. (It is redundant if all outbound
calls are not secure by default.)
Default: *19
Conference Act Code If this code is specified, the user must enter it before dialing the third
party for a conference call. Enter the code for a conference call.
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing the third
party for a call transfer. Enter the code for a call transfer.
Modem Line Toggle Code Toggles the line to a modem.
Default: *99. Modem pass-through mode can be triggered only by pre-
dialing this code.
To Next Page
Loading...
