Page 16 of 88 TP1A072–3 English
Aug 2017
Linx 10 Operating Manual —
Create, edit, and manage messages
Linx 10
3.4.3 Change the Print Delay
1 On the Home screen, touch the Message Settings button to display the Message Settings
screen. The current Print Delay value is shown on the Print Delay button (see Figure 13):
Figure 13. Message Settings screen: Print Delay
2 Touch the Print Delay button to display the Enter Print Delay screen.
3 Use the keypad to enter a new value or use the plus and minus buttons to increase or
decrease the value, and then touch the Save button to return to the Message Settings screen.
The new Print Delay value is shown on the Print Delay button. On the Enter Print Delay
screen, touch the Cancel button to discard any changes and return to the Message Settings
screen.
4 On the Message Settings screen, touch the Exit button to return to the Home screen.
3.5 Print and pause printing
To print a selected message:
To pause printing:
Option Description
Start Printing The jet starts. A jet start takes approximately 2.5 minutes. The
printer status bar displays a progress bar with the label “Jet
Starting”. When the jet startup is complete and a trigger signal is
received, the printer starts printing the message. The printer
status bar displays the message “Printing” and the Pause
Printing button is enabled.
Option Description
Pause Printing Printing stops but the jet is not stopped. The printer status bar
displays the message “Jet Running”. You can touch the Start
Printing button to quickly restart the print, or you can select a
different message to print.
Use option to stop the print for a short time (for example, to
change line and message settings). The Pause Printing button is
available only when the printer is printing.
To Next Page
Loading...
Need help?
General
