Page 35 of 88 TP1A072–3 English
Aug 2017
Linx 10 Operating Manual —
Change the printer setup
Linx 10
4.1.8 Warnings
This option allows you to prevent selected printer overspeed warnings from being reported when
they occur. Touch the Warnings button to display the Warnings screen with a list of all printer
overspeed warnings. By default all the warnings are enabled. Touch the button for the required
warning to disable that warning. Touch the button again to enable the warning.
4.1.9 Power Down
This option allows you to configure the printer for automatic powerdown under certain conditions.
The After Jet Shutdown option is set to Yes by default. All other options are set to No by default. If
no options are set to Yes, the printer will never automatically power down.
NOTE: If printer faults exist, the printer will not automatically power down.
NOTE: The values selected for these options are retained after a printer restart or software upgrade.
When auto powerdown is activated, a confirmation screen is displayed for a period of 10 seconds.
Touch the Cancel button to cancel the auto powerdown. Otherwise, if no printer activity is detected,
the printer powers down after this period has expired.
For the delayed powerdown options, any printer activity resets the delay period to its original value.
Printer activity is defined as any one of the following:
• Any events that cause the printer to print.
• Touchscreen activity (that is, if the screen is touched).
Option Description
After Jet Shutdown The printer automatically powers down once the jet shuts down.
Delayed on Idle If there is no activity (see below) during the powerdown delay time,
and the printer is in the ‘Idle’ state, the printer automatically powers
down.
Delayed on Jet Running If there is no activity during the powerdown delay time, and the
printer is in the ‘Jet Running’ state, a normal jet shutdown is
performed followed by automatic powerdown.
Delayed on Printing If there is no activity during the powerdown delay time, and the
printer is in the ‘Printing’ state, printing is stopped and a normal jet
shutdown is performed followed by automatic powerdown.
Delay Allows you to change the powerdown delay time. The delay time is
the time, in minutes, during which there must be no activity before
the powerdown sequence can begin. If any activity occurs during
the delay time the delay period is restarted.
Touch the Delay button to enter the required delay time on the
Delay screen. The minimum delay value is 1 minute and the
maximum delay value is 1440 minutes (24 hours). The default delay
value is 60 minutes.
To Next Page
Loading...
Need help?
General
