Page 76 of 88 TP1A072–3 English
Aug 2017
Linx 10 Operating Manual —
Printer communications
Linx 10
The available lines on the printer are displayed. You use the same method to select and copy
line settings as you do for messages (see page 75 for more information).
7.2.3 Copy graphics to or from USB
To copy graphics (for example, logos) from the printer to a memory device or from a memory device
to the printer:
1 On the Home screen, touch the Menu button to display the Main Menu screen, and then
touch the Backup & Restore button. The Backup & Restore screen is displayed (see Figure 2
on page 75).
2 Touch the Copy Graphics to USB or the Copy Graphics from USB button to display the
Copy Graphics to USB or the Copy Graphics from USB screen. The printer displays a list of
graphics that are saved in the printer or memory device
You use the same method to select and copy graphics as you do for messages (see page 75 for
more information).
7.3 Back up and restore printer settings
IMPORTANT: Make sure that you read and understand the following information before you back
up or restore printer settings.
CAUTION: Printer Software Damage. DO NOT remove the memory device until a backup and
restore operation is complete. If you remove the memory device before an operation is complete,
you can cause permanent damage to your printer software.
You can use a memory device to make a backup of the printer settings. You can restore the printer
settings to the same printer, or transfer printer settings to another printer.
You can back up printer settings from more than one printer to the same memory device. A backup is
saved to the memory device and identified by a name that shows the date and time of the backup in
the format ‘YYYY-MM-DD at HH.MM: SS’. For example, ‘2015-07-29 at 10:29:03’.
The printer identifies a backup from another printer with the default printer name from the
Installation screen (see ‘Installation’ on page 28 for more information), and then the date and time of
the backup. The default printer name is ‘LINX10_’, followed by the UNIC code of the printer (for
example, ‘LINX10_000012bebf90’). You can change the printer name used to identify backups on the
Installation screen. See ‘Installation’ on page 28 for more information.
You can back up the following printer settings:
• All messages and fields
• System parameters, including shaft encoder configuration and print counts
• Logos
• Date formats
• Trigger events
• Printhead parameters (for each supported printhead)
• Message orientations
• Sequential number fields
• User interface configuration
To Next Page
Loading...
Need help?
General
