L-VIS User Manual 250 LOYTEC
Version 6.2 LOYTEC electronics GmbH
11 Project Settings
Using the command Project Settings from the File menu, a number of advanced options can
be controlled which apply to the entire project. The dialog is organized in a number of
property pages, which are explained below.
11.1 Basic Settings
On this property page, the basic setup is performed. The areas of the property page are
explained in more detail below.
11.1.1 Page Protection
In this area, all options related to access control can be configured. Access control is
described in detail in section 15.1. The following data can be set:
ï‚· Setup PIN Codes: This button opens a new dialog where the 16 available access
levels can be configured. For each level, a name and a PIN code can be entered,
except for level 0 (the lowest level) which cannot be protected.
ï‚· Next download sets PIN codes: If this checkbox is selected, the next project
download will reset the PIN codes stored on the device with the codes entered in
this project. Otherwise the PIN codes of the devices are not modified. PIN codes
can be changed on the device during runtime by writing new PIN codes to the
PIN code Set system registers.
ï‚· Lock open pages after: This sets a timeout after which the system resets the
current access level back to 0, if no user input was detected (auto-logout).
ï‚· Go to default page after: This sets a timeout after which the system will switch
back to the page marked as the default page, if no user input was detected.
11.1.2 Timeout Values
This section is used to define various time limits. The following timeout values are
currently available:
ï‚· Leave edit mode after: The amount of time after which a control which is
currently in edit mode (accepting user input) and is not being used will cancel
the input operation, possibly restoring the value which was in effect before the
user input was started.
ï‚· Popup menu after: The amount of time the user has to touch the screen on an
empty area to pull up the navigation menu. In projects where navigation is
usually accomplished by custom buttons on the screen, this timeout can be set to
a high value.
To Next Page
Loading...
General