L-VIS User Manual 49 LOYTEC
Version 6.2 LOYTEC electronics GmbH
6.2 Configuring the IP-852 interface
Before the L-VIS device can be used on an IP-852 channel, the following things have to be
configured in the setup menu of the device (see also section 7.3):
1. CEA-709 Settings: If not controlled by the IP jumper, select the IP852 interface
mode on the CEA-709 settings page. The currently active interface is listed at the
bottom of this page and the corresponding button is green, the button of the
currently inactive interface is red.
2. IP Settings: Configure the IP configuration of the L-VIS device. In the setup
menu of the device, configure the IP-Address, Net mask and Standard Gateway.
Reset the device when the IP configuration and interface mode selection is
finished.
3. CEA-852 configuration: After reboot, set the Escrow time, Aggregation time
and the MD5 key on the CEA-852/RNI page of the setup menu. The CNIP port
setting should normally be set to 1628 and the NAT mode should be set to
automatic.
4. Configuration Server: Add the L-VIS device to an IP-852 channel. To do this,
either enter the IP address of the desired configuration server on the CEA-852/RNI
setup page or add the IP address of the L-VIS device to the channel list in a
configuration server, e.g. on an L-IP. In order to add the device by entering the
configuration server address, the server must have the auto-member option
enabled. No additional reboot is required.
5. Check configuration server: To check if the L-VIS device was correctly added
to the channel, enter the CEA-852/RNI page in the setup menu. The configuration
server field should now display the IP address of the configuration server.
To Next Page
Loading...
General