LOYTEC L-VIS User Manual

L-VIS User Manual 304 LOYTEC
Version 6.2 LOYTEC electronics GmbH
 Time when the device configuration has been cleared or the device was reset to
factory defaults.
 Commission of the CEA-709 node.
 Static errors in the device and data point configuration.
 System overload situations as one-time log messages since last power-on.
 Crucial communication errors as they occur.
15.10 Resource Limits
The following table specifies the applicable resource limits for different LVIS device
models. Note that some resources have hard limits, while others are basically limited by
memory and CPU capacity of the device and/or the bandwidth of the communication
channel in use. Depending on the complexity of the project regarding graphics and number
of display elements, the type of network interface in use, the required rate of data updates,
as well as the number of other devices communicating on the same channel, actual
maximum resources which are practically useable may vary significantly. These numbers
are therefore shown with a ~ to denote that they are estimates and your mileage may vary.
NOTE: Slow networks like MS/TP or FT-10 may be overloaded long before the limits specified in
this table are reached. It is the responsibility of the project engineer to design the project
according to the limits of the network and the communication peers involved.

LOYTEC L-VIS Specifications

General

Brand	LOYTEC
Model	L-VIS
Category	Monitor
Language	English