© 2011 LPKF AG HB V2.0/Dez-11 81
Pos: 28 /ED_Tec hnische_Doku mentation/2_Be dienungsanleit ung/Maschine/R P_Fräsbohrplotter/ ProtoMat_S _Serie/Prot oMat_S_Serie_IIG /Kapitel_6_Be dienung/6_08_A utomatikbetrieb @ 0\mod_ 12549044742 84_2058.docx @ 3 691 @ 2334 @ 1
6.8 Automatic mode
Every individual tool for the PCB production must be clamped into
the mill/drill head manually, if a circuit board plotter without
automatic tool change function is used.
During automatic operation single or multilayer PCBs are produced semi-
automatically. According to the prepared CBF file the tools are selected and the
drill holes and milling paths are produced.
Health hazard caused by fine particles and gases!
During machining of work pieces harmful fine particles and
gases may occur which can be inhaled!
Make sure that the dust extraction is activated during machining
of the work piece. Be sure to use fine particle filters exclusively.
Risk of injury by burning!
During the machining process the used tools and the collet
chuck heat up, direct contact may cause burnings.
Wear protective gloves and tweezers for manual change of tools
during operation.
Risk of injury by sharp edges!
The used tools are sharp-edged and cause cut or stab wounds
when used improperly.
Store the tools always in the toolbox and secure the toolbox
against unauthorised utilisation.
To Next Page
Loading...
